Fidget Switch case for multiple switches

This is a remix of the switch by kriswillcode (https://www.thingiverse.com/thing:5141239). This adds the option to make banks or rows of switches. The files with posts and holes require a minimum of one of each that are assembled back to back and then 2 case pieces will serve as the end caps. I recommend gluing the cases together where the switches go, but the post and holes should be tight enough that glue shouldn't be needed. They require some firm pressure to snap together. NOTE: DO NOT USE SUPPORTS WHEN PRINTING THE SIDE WITH HOLES! It will print fine without them. Using them will cause the hole to be filled.