Thingiverse
FIGURINE RABBIT EASTER
por catf
96
Descargas
87
Likes
0
Makes
I present to you various figurines of RABBIT for decorated your interior, ideal for a room of child 5 in all
All figures are small sizes 7 to 5 cm in length from 4 to 5 cm in width and 2.2 mm in depth
The support has been printed in PLA (black on the picture), and painted with acrylic paint then I varnished them with a spray all supports fast drying (interior / exterior) for a better holding of the paint
I added for Easter a small egg and its support and 3 rabbits thicker to stand up
3D PRINT SETTINGS
30% Sufficient filling rate if painted thereafter
70% print speed not too fast for better rendering
215 ° PLA printing temperature
60 ° shelf temperature
0.2 layer thickness
0.8 hull thickness
NO SUPPORT
PRINTING TIME 1 hr 14 min
All figures are small sizes 7 to 5 cm in length from 4 to 5 cm in width and 2.2 mm in depth
The support has been printed in PLA (black on the picture), and painted with acrylic paint then I varnished them with a spray all supports fast drying (interior / exterior) for a better holding of the paint
I added for Easter a small egg and its support and 3 rabbits thicker to stand up
3D PRINT SETTINGS
30% Sufficient filling rate if painted thereafter
70% print speed not too fast for better rendering
215 ° PLA printing temperature
60 ° shelf temperature
0.2 layer thickness
0.8 hull thickness
NO SUPPORT
PRINTING TIME 1 hr 14 min
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
