Thingiverse
Filamaster
von fonducando
0
Downloads
0
Likes
0
Makes
Filament holder that will accommodate many kinds of spools as well as many types of overhead rods.
It's 20 MM thick, which is pretty beefy. You could get away with cutting 10mm off the bottom when you slice.
Maybe even 15, but I haven't tried.
It's 20 MM thick, which is pretty beefy. You could get away with cutting 10mm off the bottom when you slice.
Maybe even 15, but I haven't tried.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
