Thingiverse
Filament Guide
von transwarp2010
10
Downloads
2
Likes
0
Makes
A nice filament-guide which gives you some controll about the bouncing filament around the work-area.
The top-tube is turnable, all parts can be mounted without any screws or glue. The guide can be mounted on top of a MeCreator 2 or on the front parts. Just slide the brackets above and put the pillar inside and the filament-guide is fixed.
The top-tube is turnable, all parts can be mounted without any screws or glue. The guide can be mounted on top of a MeCreator 2 or on the front parts. Just slide the brackets above and put the pillar inside and the filament-guide is fixed.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!