Thingiverse
Filament Guide
von B-Cup
1
Downloads
0
Likes
0
Makes
Use for one side of the spool guide I designed for the Creativity ELF printer. Not really needed when the spool is about half empty, but when the spool is full, it makes a terrible mess. This keeps the filament from flying off the sides of the spool.
Link to the spool holder:
https://www.thingiverse.com/thing:4595513
Link to the spool holder:
https://www.thingiverse.com/thing:4595513
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!