Thingiverse
Filament Sensor Mount Ender 3
von vwfan0178
42
Downloads
17
Likes
0
Makes
I wanted to add a filament runout sensor to my Ender 3 with the MicroSwiss dual gear direct drive but did not find any great options. The sensor I used is pretty generic made by several manufacturers. The filament holes line up beautifully! Since this is designed to clamp on a NEMA 17 motor and I believe all of the MicroSwiss Creality kits use the same gear setup this should fit all of the Creality MicroSwiss kits... but I cannot guarantee 100%.
Update: V2 moves the clamping nut up 3/8" for better clearance if using an e-chain on your X axis.
Hardware Required:
(1) M4X20mm BHCS
(1) M4 Jam Nut (or Regular Hex Nut)
(2) M3 Jam Nut
(2) M3X25 SHCS
Sensor Used:
https://www.amazon.com/Sunhokey-Printer-Filament-Detection-Detecting/dp/B07JJ2835X
Update: V2 moves the clamping nut up 3/8" for better clearance if using an e-chain on your X axis.
Hardware Required:
(1) M4X20mm BHCS
(1) M4 Jam Nut (or Regular Hex Nut)
(2) M3 Jam Nut
(2) M3X25 SHCS
Sensor Used:
https://www.amazon.com/Sunhokey-Printer-Filament-Detection-Detecting/dp/B07JJ2835X
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
