Thingiverse
Filament Spool Holder
door JamesK1
41
Downloads
15
Likes
0
Makes
Spool holder with different sized rods for small to large width spools. The medium sized rod will fit most spools if you just want one.
Updated 4/16/2017 - Added a wide version with a little overhang if you need to clear some acrylic pieces
Updated 5/11/2017 - Added a ptfe guide mount. This eliminates the spool backlash during retractions that can cause issues with your layer during retractions. Highly recommended. If you find that the ptfe is causing some drag issues, you can just use the mount as is without the ptfe tube.
Updated 4/16/2017 - Added a wide version with a little overhang if you need to clear some acrylic pieces
Updated 5/11/2017 - Added a ptfe guide mount. This eliminates the spool backlash during retractions that can cause issues with your layer during retractions. Highly recommended. If you find that the ptfe is causing some drag issues, you can just use the mount as is without the ptfe tube.
JamesK1 publiceert ook op
44 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
