Filament spool holding frames

**Print on side as pictured**

I printed on my CR10S-PRO and it worked a treat, Not sure whether it would work as well if scaled down though.

2 x lengths of 16mm tube are required and can be bought in most DIY stores or on eBay.

The holes in the frames were designed to allow a tie wraps or Velcro wraps to hold the tubes to the frame but I haven't attached any yet and the tubes have stayed nicely positioned on the frames and I have around 10 x 1KG spools of PLA on it at the moment.

This works as a really smart way of storing PLA in a small office or studio, the frames are very sturdy and the tubes haven't bent under the strain either which is great.