Thingiverse
Filament Spool Rack Stackable
door Sincegames
237
Downloads
159
Likes
1
Makes
This is a remix from the user guillaumeguiral.
I liked the look of his design but needed something that could be scaled as needed.
Adapted for 21mm OD tubes/pipes/rods
Designed to lock the stacks with an m5 cylinder head screw (12mm should work, else 14mm is fine) and corresponding t-nut.
Might add a normal nut version later if needed.
As usual beware of tolerances, Print the "Filament Spool TopMid STL" for a test fit and scale accordingly, you only really need a few layers to check tolerances.
My advice do a test print at 101 or 102%, for me 103% gives me a tight fit
Patch :
- Updated Top Rack as it didn't have the right thickness for a clean look, Should work as intended now
I liked the look of his design but needed something that could be scaled as needed.
Adapted for 21mm OD tubes/pipes/rods
Designed to lock the stacks with an m5 cylinder head screw (12mm should work, else 14mm is fine) and corresponding t-nut.
Might add a normal nut version later if needed.
As usual beware of tolerances, Print the "Filament Spool TopMid STL" for a test fit and scale accordingly, you only really need a few layers to check tolerances.
My advice do a test print at 101 or 102%, for me 103% gives me a tight fit
Patch :
- Updated Top Rack as it didn't have the right thickness for a clean look, Should work as intended now
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
