Thingiverse
Household
Model downloaden
Filament stand (Extendable)
622
Downloads
502
Likes
1
Makes
Filament spool holder
Consists of 2 end-pieces and as many ribs that you want in-between.
PVC plastic pipe - You need two sizes of pipes if you want to make the stand extendable. I went with 20mm and 16mm (the actual size of the 16mm turned out to be 15,86mm but I fixed it with 2 laps of tape where its hidden inside the 20mm to keep it centered).
If you're not interested in a extendable stand, then the bigger of the two (20mm) will suffice, however, the smaller one adds a lot of stability to the construction.
* PETG filament (or similar strength)
* Tube - Diameter: 20mm
* Tube - Diameter: 16mm
* Glue (preferably expandable)
Consists of 2 end-pieces and as many ribs that you want in-between.
PVC plastic pipe - You need two sizes of pipes if you want to make the stand extendable. I went with 20mm and 16mm (the actual size of the 16mm turned out to be 15,86mm but I fixed it with 2 laps of tape where its hidden inside the 20mm to keep it centered).
If you're not interested in a extendable stand, then the bigger of the two (20mm) will suffice, however, the smaller one adds a lot of stability to the construction.
* PETG filament (or similar strength)
* Tube - Diameter: 20mm
* Tube - Diameter: 16mm
* Glue (preferably expandable)
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
