Thingiverse
Filament Stand
door mindcode
268
Downloads
245
Likes
2
Makes
Filament Stand - V1
Its adaptable to every filament spool width. Just adjust the both stands on the rail.
The parts are very narrow dimensioned, it may require force to put everything together.This is intented in order to provide a good behaivor and cohesion, so be careful. Don't hesitate to raise the infill more above 25% because of that.
You are going to need bearings: 608 ZZ
Inner diameter: 8 mm
Outer diameter: 22 mm
Width: 7 mm
Its adaptable to every filament spool width. Just adjust the both stands on the rail.
The parts are very narrow dimensioned, it may require force to put everything together.This is intented in order to provide a good behaivor and cohesion, so be careful. Don't hesitate to raise the infill more above 25% because of that.
You are going to need bearings: 608 ZZ
Inner diameter: 8 mm
Outer diameter: 22 mm
Width: 7 mm
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
