Fillenium Malcon (Simplified)

A remix of the famous "Fillennium Malcon" without some of its features, that, for me, ruined the print a little bit.
I recommend that you read what I changed and then choose what suits you best!

**What I did:**
**- V1 -**
* Rotated it 90 degrees (To make it harder to fall on print beds that move).
* Fixed some model issues (Easier for your slicer to read, doesn't affect prints).
* Removed the 52 tubes on the bottom of the ship (A detail I think is unnecessary and an issue I had to solve after the print is done).

**- V2 -**
* Further removed 12 more tubes scattered around the ship (I hate tubes).

**- V3 -**
* Made some edges at the center of the ship (on both sides) less sharp.
* Removed a thin surface under the ship at the bottom (Same problem as the tubes, too thin to print).

**If you want to edit further, there's a "Blender 2.79b" save file in the file section**