Thingiverse
Fillenium Stand
von guimmer
23
Downloads
20
Likes
0
Makes
https://youtu.be/h6GmKxB_cDY
I Printed a model of the Fillenium Malcom (http://www.thingiverse.com/thing:919475)
I wanted a good way to display it so I quickly designed this stand in Tinkercad.
I wanted to use the Fillenium Malcom model to shape the top of the stand but it is too complex of a model for Tinkercad.
I glued the base a little to one side where there were two flat spots that matched the two profiles.
I Printed a model of the Fillenium Malcom (http://www.thingiverse.com/thing:919475)
I wanted a good way to display it so I quickly designed this stand in Tinkercad.
I wanted to use the Fillenium Malcom model to shape the top of the stand but it is too complex of a model for Tinkercad.
I glued the base a little to one side where there were two flat spots that matched the two profiles.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
