Fire & Smoke Marker

I created my own smaller base and smoke effect to go with the fire I got from SpankyTaz. I split the design down the middle so I can do filament changes. Then after printing I glued the 2 sides together and pressed it into the base. The base is a tight friction fit and is slightly off-centered on purpose. The smoke drifts to one side so make sure the longer side between the edge and the hole is under where the smoke drift. This helps with the balance. I use these as destroyed markers in World of Tanks. I printed in natural but painted it black because I was out of black PLA. I also used the new "Ironing" feature in Prusa Slicer to have a smooth, no-line finish.