Fireboard BBQ Temperature Controller Mount

This is a case and mount for a Fireboard 2 and Fireboard 2 Drive, both are the same size.

I wanted a stand for my Fireboard 2 Drive that would be sturdy and not easily knocked over. This works.

Requires 8 ea. 7/16" #2 screws.

No supports needed.

NOTE: There is a comment below that for some reason Thingiverse, with its broken shitcode programming, will not allow me to "reply" to in the Comments section regarding the print size. Here is what my response should read:

For some reason Thingiverse will not let me reply to austingeorge's post. The problem is NOT with the files included, they work perfectly as posted. No "compensation" was applied in printing these parts. So far to my direct knowledge, they have been printed on Artillery X1's (two machines), an ANET A-8, a Creality CR-10 and a Ender 3. I have never heard of the printer you referenced so cannot comment on that, but no one else has had a problem.