Thingiverse
Firework pull ring ignitor
door Dapaca
65
Downloads
53
Likes
0
Makes
Pull ring ignitor for fireworks like smoke bombs, firecrackers etc..
Glue (i use hot glue) 2 matches together and attach/glue them to the firework, then glue the fuse to the matches touching the part that ignites in the middle of the 2 matches, cut off some of the striker from the match box and glue inside the 3d printed part, add some string or wire, push the 3d printed part slowly on-top.
NOTE: i used TPU and never tried PLA or something tough yet but it should be ok.
Glue (i use hot glue) 2 matches together and attach/glue them to the firework, then glue the fuse to the matches touching the part that ignites in the middle of the 2 matches, cut off some of the striker from the match box and glue inside the 3d printed part, add some string or wire, push the 3d printed part slowly on-top.
NOTE: i used TPU and never tried PLA or something tough yet but it should be ok.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
