Thingiverse
Flag Pole
von joebejm
8
Downloads
7
Likes
0
Makes
UPDATE: To My Flag Pole. Change my flag holders to be used with
“fiberglass marking stakes” which they are ¼" Dia. (About 6.5mm). They are Glue to the holders. I used hot glue so if I need it I can remove easy. Or you can find something else.
What it makes that when is windy the stakes can rotate both holders together. With out them so many times ends of the flag are getting twisted.
I included a spacer that goes inside the rivets of the flag so it will prevent bending brackets when tightening the screws.
There are STL and Step File included.
Flag Pole made from 3/4 (26.75mm) PVC Pipe. Included are pictures for Information on mounting and put it together.
“fiberglass marking stakes” which they are ¼" Dia. (About 6.5mm). They are Glue to the holders. I used hot glue so if I need it I can remove easy. Or you can find something else.
What it makes that when is windy the stakes can rotate both holders together. With out them so many times ends of the flag are getting twisted.
I included a spacer that goes inside the rivets of the flag so it will prevent bending brackets when tightening the screws.
There are STL and Step File included.
Flag Pole made from 3/4 (26.75mm) PVC Pipe. Included are pictures for Information on mounting and put it together.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
