Thingiverse
Flashforge Creator Pro Camera Mount
von jsyar
81
Downloads
49
Likes
2
Makes
Camera Mount for the 2016 Flashforge Creator Pro. Mount is installed on the left side of the printer (as facing printer),which allows the printer door to be opened while the camera is installed. A slightly longer screw is needed for the side and the original screw can be used for the front of the mount. I used a longer screw that I had in my supplies, which required a spacer as shown in the photo. The spacer would not be required with the correct length screw.
Several screenshots of the video are included for perspective. A Logitech C615 camera is mounted via a 1/4 inch screw (the standard camera mount screw). The camera is wired to a Raspberry pi running Octoprint. Octoprint allows the camera to be inverted and mirrored, which is required to display the video and photos from the camera in the correct orientation.
Several screenshots of the video are included for perspective. A Logitech C615 camera is mounted via a 1/4 inch screw (the standard camera mount screw). The camera is wired to a Raspberry pi running Octoprint. Octoprint allows the camera to be inverted and mirrored, which is required to display the video and photos from the camera in the correct orientation.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
