Thingiverse
Flashforge Creator Pro Internal Camera Mount
door RJ_Make
67
Downloads
38
Likes
0
Makes
*** 2 Updates ** 03/09/17
1) Added an angle mount for use with the SainSmart RPi camera (https://www.amazon.com/gp/product/B00N1YJKFS/ref=oh_aui_detailpage_o04_s00?ie=UTF8&psc=1) Use double sided foam tape to attach camera to mount. The hole in the back is to allow you to push on the tape/camera to help make removal easier. It is NOT for the camera lens to go through.
2) Modified the main mount to fit the Flashforge table back plate tighter.
Simple camera bracket that utilized the Flashforge Creator Pro table back plate.
I made this into 2 pieces to avoid printing a major support system. You will still need to supports, but only for the small area that attaches to the back plate.
Notes:
ABS, 30% Infill
1) Added an angle mount for use with the SainSmart RPi camera (https://www.amazon.com/gp/product/B00N1YJKFS/ref=oh_aui_detailpage_o04_s00?ie=UTF8&psc=1) Use double sided foam tape to attach camera to mount. The hole in the back is to allow you to push on the tape/camera to help make removal easier. It is NOT for the camera lens to go through.
2) Modified the main mount to fit the Flashforge table back plate tighter.
Simple camera bracket that utilized the Flashforge Creator Pro table back plate.
I made this into 2 pieces to avoid printing a major support system. You will still need to supports, but only for the small area that attaches to the back plate.
Notes:
ABS, 30% Infill
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
