Flashforge Creator Pro Raspberry Pi Camera Mount 2016

I liked the design by kenotic and was ready to download, only to realize the newer 2016 Flashforge Creator Pro's don't have the little holes in the top corners any longer, so the design doesn't work with the newer models. I found a cool spot in the corner to mount it and remixed their design. My design makes use of the screw and hole on the left side of the Flash Forge. The stock screw is too short so you need to pick up an M4 x 16mm screw and an M4 wingnut (and M4 washer or lockwasher if you would like). Simply take out the stock screw and replace it with the new one. Place the mount over the screw and bolt on the wing nut.

I have 2 different length sizes of the mount: Tall and Tallest. Goes past the height of the motor carriage but mine has yet to be hit. Having different lengths gives you the ability to decide which version works best for you. The pics taken are using the Tall version.

The v1 cam knob is for v1 pi cameras and the v2 knob is for v2 pi cameras (unaltered and ta