Thingiverse
FlashForge Creator Tangle Preventer
door Miaviator
15
Downloads
7
Likes
0
Makes
By default the filament loading tube is to close to the body of the FlashForge and to far from the rim of the filament spool. This tiny little clip holds the loading tube out a little bit and prevents the stupid tangle from occurring around the filament spool holder. 10 minute print saved hours of tangles and jams.
Scale is in inches so: 254 multiplier for some slicing software. 2.54 CM per inch. 25.4 MM per inch.
Scale is in inches so: 254 multiplier for some slicing software. 2.54 CM per inch. 25.4 MM per inch.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
