Flashforge internal webcam mount

This is a webcam mount for use inside of a Flashforge Creator Pro. The webcam I used is a "USB100W07M" and comes on a 26x26mm PCB with holes for M2 screws. It claims to have a viewing angle of 120˚.

My Flashforge is the 2016 model. On the inside of the frame's front left wall there are threaded studs. On the right side of the printer the same studs are used for cable management, but the left side has no cables. You'll need two M3 nuts to attach the mount to these. I also put two washers behind the mount on each stud.

There's already a hole in the corner under the webcam to thread the cable through.

I printed mine on a fairly cheap i3 clone. It didn't come out pretty but is strong enough.