Flat test square
por Toothfairy_
39
Descargas
22
Likes
0
Makes
This is just a flat square, to test the bed level.
In Cura, put it int the middel and save it as a standard quality 0.2mm
There's a 1 layer of 0.2mm and a 5 layer of 0.2mm
Print it out in the middle of the bed.
The print should be consistent and flat.
When this it pretty ok, you can start with your auto bedleveling procedure.
In Cura, put it int the middel and save it as a standard quality 0.2mm
There's a 1 layer of 0.2mm and a 5 layer of 0.2mm
Print it out in the middle of the bed.
The print should be consistent and flat.
When this it pretty ok, you can start with your auto bedleveling procedure.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
