Thingiverse
flat tripod
door dctsystems
4
Downloads
4
Likes
0
Makes
I got a nice table tripod, with ball head, but even that was to large/high for what I wanted so I made this "flat tripod". Mounting a camera onto is places it right on the ground, and adding a ball head gives you something really small/low.
It holds a Canon M series fine but would be too small for an SLR.
You'll need a tripod screw to attach the camera.
It prints fine the normal way up - there's a bit of mess underneath but you can just clean that out and its fine.
It holds a Canon M series fine but would be too small for an SLR.
You'll need a tripod screw to attach the camera.
It prints fine the normal way up - there's a bit of mess underneath but you can just clean that out and its fine.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!