Slicer Discord
Flea Collar Quick Release Adapter – 3D printable model from MakerWorld MakerWorld
Pets

Flea Collar Quick Release Adapter

by JellyBean · Pets
5 Downloads
4 Likes
3 Makes
Go to Model
So if you have a dog/cat you know one of the on-going never ending battles is fleas. So you buy a new flea collar for your furry family member every 6 months and they get relief so all is well…. until its bath time. Yes most flea collars state they're fine to get wet, but i've always taken that as maybe your dog out in the rain for a few minutes or jumping through a puddle being playful, etc and not necessarily fully submerged into a bath. So i personally remove the collar (that is designed to be put on and cut off when removing) and it takes ages, and is uncomfortable to say the least for my dog Beans. After his most recent bath I stared at the collar in my hands and I swear you could see the light bulb that immediately emitted above my head. After a few iterations and test fits my flea collar quick release adapter came to be. Simply slide the adapter into the collar and wrap it around your furbabies neck and use the retainer half to clasp it into place. And when it's bath
Category
Pets
Source
MakerWorld
Published
Updated
What you need to print this: Beginner Low confidence
Single piece
Supports 1/3
Assembly 0/3
Settings 1/3
Bed size 0/3
Post-process 0/3
Printer
FDM / FFF
File format
STL
Material
PLA
Software
Cura, PrusaSlicer, or similar
Same designer, more platforms

JellyBean also publishes on

4 additional models across 1 more platforms

Verified by matching model titles across platforms.
No ratings yet
No comments yet – be the first!

Similar Models

6 Suggestions
Feed Blog Slicer Cost Calculator Image Search Submit Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Add to Collection