Slicer Discord
Flea Collar Quick Release Adapter – 3D-Druckmodell von MakerWorld MakerWorld
Pets

Flea Collar Quick Release Adapter

von JellyBean · Pets
5 Downloads
4 Likes
3 Makes
Zum Modell
So if you have a dog/cat you know one of the on-going never ending battles is fleas. So you buy a new flea collar for your furry family member every 6 months and they get relief so all is well…. until its bath time. Yes most flea collars state they're fine to get wet, but i've always taken that as maybe your dog out in the rain for a few minutes or jumping through a puddle being playful, etc and not necessarily fully submerged into a bath. So i personally remove the collar (that is designed to be put on and cut off when removing) and it takes ages, and is uncomfortable to say the least for my dog Beans. After his most recent bath I stared at the collar in my hands and I swear you could see the light bulb that immediately emitted above my head. After a few iterations and test fits my flea collar quick release adapter came to be. Simply slide the adapter into the collar and wrap it around your furbabies neck and use the retainer half to clasp it into place. And when it's bath
Kategorie
Pets
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Software
Cura, PrusaSlicer o. Ä.
Gleicher Designer, mehr Plattformen

JellyBean veröffentlicht auch auf

4 zusätzliche Modelle auf 1 weiteren Plattformen

Verifiziert durch übereinstimmende Modelltitel über Plattformen hinweg.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen