Thingiverse
Fleshlight case
door Didgitalpunk
164
Downloads
119
Likes
0
Makes
A replacement case for fleshlights.
Use a 61.5mm id, 5.5mm high * 5mm wide cross section rubber seal on the bottom.
you can probably find a close enough fit on McMasterCarr if you have access to it, or you can print the 'cap no seal' version of the end-cap, which doesn't require a rubber seal.
Use a 61.5mm id, 5.5mm high * 5mm wide cross section rubber seal on the bottom.
you can probably find a close enough fit on McMasterCarr if you have access to it, or you can print the 'cap no seal' version of the end-cap, which doesn't require a rubber seal.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
