Thingiverse
Flight Case
door Royden99
5
Downloads
19
Likes
0
Makes
I modified this awesome flight case/lunchbox thing by Greg_The_Maker to fit on a Prusa MK4S print bed (210x250mm).
In my case it's barely big enough to hold my 3.5" FPV drone, goggles, controller, and a couple batteries.
Summary:
* "Flight_Case_Top" is deepened so it's the same height as the bottom piece.
* "Flight_Case_Top," "Flight_Case_Base," and "Flight_Case_Seal" are squished on the X-axis and stretched on the Y-axis to be the maximum footprint allowed by my printer.
* All divider notches removed from "Flight_Case_Base" and "Flight_Case_Top."
* Printed in PETG, but not sure I would recommend doing that without an enclosure as I got a lot of warping.
* I used button-head M4 machine screws, nuts, and washers instead of grub screws. I did have to reem out a few holes with a drill to allow them to fit.
* The original handle, catch, and catch arm still fit properly.
In my case it's barely big enough to hold my 3.5" FPV drone, goggles, controller, and a couple batteries.
Summary:
* "Flight_Case_Top" is deepened so it's the same height as the bottom piece.
* "Flight_Case_Top," "Flight_Case_Base," and "Flight_Case_Seal" are squished on the X-axis and stretched on the Y-axis to be the maximum footprint allowed by my printer.
* All divider notches removed from "Flight_Case_Base" and "Flight_Case_Top."
* Printed in PETG, but not sure I would recommend doing that without an enclosure as I got a lot of warping.
* I used button-head M4 machine screws, nuts, and washers instead of grub screws. I did have to reem out a few holes with a drill to allow them to fit.
* The original handle, catch, and catch arm still fit properly.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!