Flip Stop

I designed this flip-stop to fit the wide track on my cross-cut sled. Rather than an arrow I use the corner of the stop to line up with the measurement on the tape. My original thought was to off-centre the M6 hole where the clamp fits then use an M5 flat head bolt to line up with the corresponding measurement but instead I extruded the stop to a thickness that would line up the corner of the main block with the measurement on the tape.

You will need:
M6 knob or lever
M5 bolt
An M5 nut if you want to secure the bolt from the access hole underneath. I didn't bother.