Thingiverse
FLIR Ex (E4/E5/E6/E8) Tripod Mount
von jamesbastow
39
Downloads
30
Likes
1
Makes
I wanted a tripod adapter that used regular hardware - what I had on hand. This design uses a captive 1/4-20 nut.
Materials required:
- 1/4-20 UNC nut
- M3 x 0.5 nut (x2)
- M3 x 6 screw (x2)
If the nuts don't fit easily, use a bit of hot air to soften the plastic before pushing them in.
I've also published the SolidWorks design files.
Materials required:
- 1/4-20 UNC nut
- M3 x 0.5 nut (x2)
- M3 x 6 screw (x2)
If the nuts don't fit easily, use a bit of hot air to soften the plastic before pushing them in.
I've also published the SolidWorks design files.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
