Thingiverse
Flite Test P-47 formers
door Millhouse_5
18
Downloads
12
Likes
0
Makes
Fuselage formers for the Flite Test P-47 Thunderbolt.
Make all of your formers dimensionally perfect without even having to touch a piece of foam board. Excellent if your just don't want to bother cutting out a ton of pieces or if you're trying to make your new plane as robust as possible.
Only one of each former is required. If printed with two top and bottom layers as well as two walls and minimal infill each piece is a similar weight to foam. However if you want more strength, then just go nuts.
Printed with basic PLA my formers were plenty strong and could handle the heat from a 60W glue gun without deforming.
This is my first of the FT master series former sets and I hope to complete more in the future.
Make all of your formers dimensionally perfect without even having to touch a piece of foam board. Excellent if your just don't want to bother cutting out a ton of pieces or if you're trying to make your new plane as robust as possible.
Only one of each former is required. If printed with two top and bottom layers as well as two walls and minimal infill each piece is a similar weight to foam. However if you want more strength, then just go nuts.
Printed with basic PLA my formers were plenty strong and could handle the heat from a 60W glue gun without deforming.
This is my first of the FT master series former sets and I hope to complete more in the future.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
