Floating coaster

This is a “floating” coaster. The two platforms hold each other with the chains with opposite forces to create a floating looking coaster. You will need to print:2x coaster_base.stl10x coaster_anchor.stl20x coaster_chain_link.stl1x center_ring.stl InstructionA: Install the center anchors and ring. It can be a little tricky to install. Here is how I did it: 1- Pass an anchor trough the center ring and clip the anchor (with the ring) to one of the base. 2- Using long pliers, hold an anchor and pass it trough the center ring. (keep holding) 3- With your other hand, position the other base and insert one end of the anchor in the hole. (keep holding) 4- Using the plyers, insert the other end of the anchor in the other hole.B: 1- Create four chains of five chain links 2- Pass an anchor trough the end of a chain link and clip the anchor in one of the corner holes of a base. 3- Pass an anchor trough the other end of the chain and clip it to the corresponding corner hole in the other base (make