Flow Test - Visual and Fast!

This is a test model that can be printed quickly. By looking at it you can see if you set your flow (aka extrustion multiplier) correctly.There is couple of surfaces with overlaping features, so you can look if you have some gaps, or overextrusion. It uses less than 4g of filament and prints in about 6-15 minutes - depending on your printer. It is suitable for both 0.4 and 0.6mm nozzles.Printing instructions0.2mm layer height2 walls, 3 top and bottom layers20% infill I have found that for me 1.0 (100%) flow usually works for PLA, and 0.94 (94%) for ASA. When I get a new colour, I try these defaults on this print and if needed, change the flow by 0.01 (1%) either up or down. My Twitter :) In case you have any requests, feel free to send me a message and I will try to help you out!