Thingiverse
Flower Pot
von NickAmes
100
Downloads
82
Likes
1
Makes
A simple flower pot with a drainage hole.
The default dimensions are 5.6 cm top diameter and 5 cm tall, but you can scale it to whatever you want.
The gcode was produced using the default ReplicatorG skeinforge settings.
Update Aug 28 2009:
Fixed up mesh in blender.
Update Aug 27 2009:
I've found that Tower seems to cause problems when generating gcode with skeinforge.
If you have problems, try turning Tower off.
Update July 10 2009:
Increased the wall thickness from 2 mm to 3 mm.
The default dimensions are 5.6 cm top diameter and 5 cm tall, but you can scale it to whatever you want.
The gcode was produced using the default ReplicatorG skeinforge settings.
Update Aug 28 2009:
Fixed up mesh in blender.
Update Aug 27 2009:
I've found that Tower seems to cause problems when generating gcode with skeinforge.
If you have problems, try turning Tower off.
Update July 10 2009:
Increased the wall thickness from 2 mm to 3 mm.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
