Thingiverse
Flower Test
von cryan329
30
Downloads
34
Likes
0
Makes
I created this as a test for my self, and my machine. How fine of detail can I achieve, and what layer thickness is possible with my printer before failure. The original file that I created has .01mm of displacement on the pedals of the flower. The pedals themselves were only thickened to .05mm for the larger four bottom pedals, then the inner pedals were at .03mm.
This is a test of calibration, layer lines/ height, how gentle the printer is, and also the type of resin or filament you choose. Good luck to those that try this as my first print was roughly 90% successful.
Can't wait to see what you can do with this
My resin of choice for this was elegoo abs like smoky black. Not the best for a benchmark test but it worked... my print time was 35m 16s.
This is a test of calibration, layer lines/ height, how gentle the printer is, and also the type of resin or filament you choose. Good luck to those that try this as my first print was roughly 90% successful.
Can't wait to see what you can do with this
My resin of choice for this was elegoo abs like smoky black. Not the best for a benchmark test but it worked... my print time was 35m 16s.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
