Slicer Discord
Floyd Pepper – 3D-Druckmodell von Thingiverse Thingiverse

Floyd Pepper

von mathias42
26 Downloads
29 Likes
0 Makes
Zum Modell
I wasn't intending to do up a Floyd since I already have a nice Palisades figure, but my OCD took over and it bugged me that he wasn't up here. Looking at the body, I realized I could still re-use that same Shaggy body I've been using for Zoot and Lips. I sliced the middle to pull it out a bit and create the band uniform seam, then added buttons epaulets and knots.

Floyd's head is tricky. It's in the placement of those eyes - the way they are actually set up above the hairline and are in fact a bit taller than the head itself. I swiped Scruffy's hat off of Beauregard to top it off and then used my go to pigtails from Tani modle for tufts of hair to make eyebrows and the pony tail.

Speaking of pony tails, I swiped one off of an MLP Derpy to create his handlebar mustaches. User plenet has created a BUNCH of MLP ponies and it gave me a great variety to choose from. (Those are wonderful models. Go check them all out!). Finished up with hair from Einstein Sculpture Bust 3D Scan by 3
Quelle
Thingiverse
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Warum?
Supports nötig
Einteilig Supports nötig
Supports 2/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen