Thingiverse
FLSUN Orbiter Aero
door Ghost_in_the_Print
14
Downloads
12
Likes
0
Makes
A minimal mount for the Obiter1.5 and 2.0 extruder to FLSUN SR. It has some Air canals which lead the Air from the hotend cooler to the extruder motor for passive cooling.
When installing, you have to change the current for the nema 14 motor in following steps:
take a small screwdriver and set the driver on the motherboard to 0.6A.
then connect to a terminal like octoprint, pronterface cura etc. and type these commands:
M92 E710 ; change the extruder steps to 710
M906 T0 E400 ; drop the current for NEMA14 to 400 ma so we don't burn it out
M500 ; save settings to EEPROM
Depending on what stepper motor you use, the current above may need to be altered.
If you don't have terminal available, highlight and copy the settings above and paste into a text editor and save it to the usb drive you use for printing, using a ".gcode" file extension, then print the file. That will update your printer and save the settings.
When installing, you have to change the current for the nema 14 motor in following steps:
take a small screwdriver and set the driver on the motherboard to 0.6A.
then connect to a terminal like octoprint, pronterface cura etc. and type these commands:
M92 E710 ; change the extruder steps to 710
M906 T0 E400 ; drop the current for NEMA14 to 400 ma so we don't burn it out
M500 ; save settings to EEPROM
Depending on what stepper motor you use, the current above may need to be altered.
If you don't have terminal available, highlight and copy the settings above and paste into a text editor and save it to the usb drive you use for printing, using a ".gcode" file extension, then print the file. That will update your printer and save the settings.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
