Thingiverse
FLSUN Q5 integrated lighting system
277
Downloads
156
Likes
4
Makes
**An integrated lighting system that doesn't get in the way and hides all cables for the brightest and cleanest printing experience. For 100% discount use code "Strat" at checkout.**
Now for the serious stuff =>
There are several configurations you can make of this thingie. You can put one of those LED strips in each of the printer pylons, or you can do only two of them, or only one. Or you can use only 1 LED strip segment per pylon instead of 2. It's entirely up to you.
Another thing to mention is that you can do it with minimal effort or you can do it like me with a bit more complex execution.
**Basic setup requirements**
- Components:
- Wire length of 2m to 2.5m (22AWG is recommended, but 24AWG should be okay too)
- LED strip of 1m (60 LEDs) non waterproof (1m is usually the minimum you can buy)
- Tools:
- Soldering iron
**Complex execution setup requirements**
+ Components:
- Wire length of 2m to 2.5m (22AWG is recommended, but 24AWG should b
Now for the serious stuff =>
There are several configurations you can make of this thingie. You can put one of those LED strips in each of the printer pylons, or you can do only two of them, or only one. Or you can use only 1 LED strip segment per pylon instead of 2. It's entirely up to you.
Another thing to mention is that you can do it with minimal effort or you can do it like me with a bit more complex execution.
**Basic setup requirements**
- Components:
- Wire length of 2m to 2.5m (22AWG is recommended, but 24AWG should be okay too)
- LED strip of 1m (60 LEDs) non waterproof (1m is usually the minimum you can buy)
- Tools:
- Soldering iron
**Complex execution setup requirements**
+ Components:
- Wire length of 2m to 2.5m (22AWG is recommended, but 24AWG should b
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
