Thingiverse
Flush Light Mount Bracket- Ender 3 V3 KE
von TheSkootz
3
Downloads
2
Likes
0
Makes
12/03/25 : Update : Added combined bracket to print in one piece.
A custom flush light mount that clips into the top bar of the Ender 3 V3 KE printer (and possibly SE however I'm not sure). The design has side walls to stop light going into your eyes and ensures if focuses down onto the printer.
All you need is an LED light strip to put into the channel of the bracket, I just used one from Kmart and ran the wires into the printer frame and down. I've connected this using a 24-12v step down and connected to the printer, with a switch to be able to turn them on and off.
Printed in two parts and superglued together. A bit of Bluetack was used just to keep the bracket in place a bit more but fits well without this. Can be printed in the combined state with supports.
A custom flush light mount that clips into the top bar of the Ender 3 V3 KE printer (and possibly SE however I'm not sure). The design has side walls to stop light going into your eyes and ensures if focuses down onto the printer.
All you need is an LED light strip to put into the channel of the bracket, I just used one from Kmart and ran the wires into the printer frame and down. I've connected this using a 24-12v step down and connected to the printer, with a switch to be able to turn them on and off.
Printed in two parts and superglued together. A bit of Bluetack was used just to keep the bracket in place a bit more but fits well without this. Can be printed in the combined state with supports.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
