Flush Side Cutters

by FVCKSIMILE · 3D Printer Accessories

70 Downloads

22 Likes

33 Makes

hey Folks, This small support for flush side cutters was simple to make but satisfying.It's my first tool holder, I hope you like it. I have inserted a cavity inside it in which you can insert a magnet. To Layer 10 just insert a pause as I show you in the figure, so that the printer can stop and you can insert the magnet. To be on the safe side I put a drop of glue under it. I used a neodymium magnet, as you can see in the photo, about 10mm x 1.7mm. Done this just restart the press and you're done. If you have any questions, write me an email or a comment ( [email protected] This is my email).