MakerWorld
3D Printer Accessories
Ver Modelo
Flush Side Cutters
70
Descargas
22
Likes
33
Makes
hey Folks, This small support for flush side cutters was simple to make but satisfying.It's my first tool holder, I hope you like it. I have inserted a cavity inside it in which you can insert a magnet. To Layer 10 just insert a pause as I show you in the figure, so that the printer can stop and you can insert the magnet. To be on the safe side I put a drop of glue under it. I used a neodymium magnet, as you can see in the photo, about 10mm x 1.7mm. Done this just restart the press and you're done. If you have any questions, write me an email or a comment ( [email protected] This is my email).
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
