Thingiverse
Hobby
Zum Modell
Fly Case
851
Downloads
601
Likes
2
Makes
Small magnetic case for holding fly fishing flies.
Uses the following magnets
* 2mm diameter x 5mm height cylinder [4]
* 12mm diameter x 2mm height cylinder [2]
I didn't have any 12mm x 2 mm magnets so I stacked 12mm x 1mm magnets instead.
Pause the print at 4mm to add the 12mm magnets to the center of the case. Pause at 0.4mm if you want to change out the material like in the pictures above.
The hinge part of the case should be made with a flexible plastic (I used MadeSolid PET+)
Uses the following magnets
* 2mm diameter x 5mm height cylinder [4]
* 12mm diameter x 2mm height cylinder [2]
I didn't have any 12mm x 2 mm magnets so I stacked 12mm x 1mm magnets instead.
Pause the print at 4mm to add the 12mm magnets to the center of the case. Pause at 0.4mm if you want to change out the material like in the pictures above.
The hinge part of the case should be made with a flexible plastic (I used MadeSolid PET+)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
