Thingiverse
Flying Needle
von Saarbruecker
3
Downloads
2
Likes
0
Makes
Hello,
Things you need beside the printed parts:
- 10x10x10mm cube magnet (easy to find on google)
- magnetic needle
- string (as thin as possible, to get the flying/hovering effect)
Mounting:
But the magnet inside the "L". Make sure you bring the magnetic side in the right direction. Then close it with the cap.
Then knot the string around needle. At the other side of the string make an ribbon. Then you can use the pillars on the downside to adjust the string to a fitting length.
Things you need beside the printed parts:
- 10x10x10mm cube magnet (easy to find on google)
- magnetic needle
- string (as thin as possible, to get the flying/hovering effect)
Mounting:
But the magnet inside the "L". Make sure you bring the magnetic side in the right direction. Then close it with the cap.
Then knot the string around needle. At the other side of the string make an ribbon. Then you can use the pillars on the downside to adjust the string to a fitting length.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
