flying rocket

this flies very far if you use a very large rubber band, so print in very bright colors so you can find it again.
print at 100% infill with no supports. I added a small support to the bottom of the rocket's launching spur, so you will need to cut this off.
wrap a rubber band (the bigger, the better) once around the thin part of the launch stick, as shown in picture 3, place the rocket's launching spur on the other end of the band and hold it as shown in picture 4, aim between 45 and 90 degrees up, and let fly. Just after you release the rocket, bring the launching stick down so the rocket doesn't hit it.
Optional: roll a dollar bill or similar sized piece of paper tightly and place it in the exhaust hole.