MakerWorld
Festivities
Ver Modelo
Flying snowflake
98
Descargas
38
Likes
49
Makes
No supportAfter printing, for the one in the air all you have to do is break out the small tower in the middle, rotating is the trick.You should hold the snowflake firmly for this.For the one the plate, bend the plate then hole the snowflake where it's loose and bend again.I recommend white Silk PLA, gold and silver have also given quite good results. I optimized this print profile for BambuLab Wihte Silk. And Sunlu also worked without a problem.Make sure that you use dry filament, you may still have a little stringing. If you want to optimize this, reduce the temperature in 3 °C steps. I also had results that I was happy with, but I like to hear the feedback.Boost Me
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
