Thingiverse
Foldable Face Shield
door TheProbe
2
Downloads
4
Likes
1
Makes
No Supports Required
it's a foldable FaceShield, i tested it and it works.
Tip: you could try using felte pads (the one you use on the chairs legs etc.) to create thickness and completely avoid front visor disassemble and to better maintain the open position
To connect the transparent foil, make a hole in the foil, then take a little piece of 3D print filament, put it trough the foil and the holes of the front visor and then use a hot knife to flat both side of the filament. you could use cable tie
it's a foldable FaceShield, i tested it and it works.
Tip: you could try using felte pads (the one you use on the chairs legs etc.) to create thickness and completely avoid front visor disassemble and to better maintain the open position
To connect the transparent foil, make a hole in the foil, then take a little piece of 3D print filament, put it trough the foil and the holes of the front visor and then use a hot knife to flat both side of the filament. you could use cable tie
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
