Thingiverse
Foot 3d-plexi-printer
von steijlen
10
Downloads
6
Likes
0
Makes
This is a foot for my new plexi printer. The sides of the printer body will be made out of 5mm plexi glass. They will fit into these foot.
The front foots are 30mm x 30mm, the back foots are 50mm x 50mm. Both 10mm high (inside), angel of 45 degrees.
I will upload the drawings for the body panels soon so you can see how it is ment to be used.
The front foots are 30mm x 30mm, the back foots are 50mm x 50mm. Both 10mm high (inside), angel of 45 degrees.
I will upload the drawings for the body panels soon so you can see how it is ment to be used.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
