Thingiverse
For Heat insert practice
0
Downloads
0
Likes
0
Makes
This is a test piece for training heat inserts.
The hole diameter is set to exactly Φ4, which may result in a narrower output in the print setting.
In that case, please extend it with a drill of Φ4
Knurled insert nut M3 x 4mm L x 5mm OD x4 piece
Printer:
Snapmaker J1
(I have listed it here because there is no J1 in the selections)
The hole diameter is set to exactly Φ4, which may result in a narrower output in the print setting.
In that case, please extend it with a drill of Φ4
Knurled insert nut M3 x 4mm L x 5mm OD x4 piece
Printer:
Snapmaker J1
(I have listed it here because there is no J1 in the selections)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!