Thingiverse
formula flip car
von tomastnt_cz
3
Downloads
8
Likes
0
Makes
Just a toy.
Easy to print, no supports needed. Made of PLA, layer 0.3
You need to glue few things together (spoiler holders, left and right sides of body)
And you need an axis of course. 3mm diameter hard wire should do the job (I used "strong" copper wire).
Tires are printed of PLA too. So, it doesnt have a simgle bit of a traction and it spins all the time, funny.
Inspired by Double-sided formula 1 from mikimaus_cz.
Easy to print, no supports needed. Made of PLA, layer 0.3
You need to glue few things together (spoiler holders, left and right sides of body)
And you need an axis of course. 3mm diameter hard wire should do the job (I used "strong" copper wire).
Tires are printed of PLA too. So, it doesnt have a simgle bit of a traction and it spins all the time, funny.
Inspired by Double-sided formula 1 from mikimaus_cz.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!