Slicer Discord
3DSEARCH / FPV Camera Mount
FPV Camera Mount – 3D-Druckmodell von Thingiverse Thingiverse

FPV Camera Mount

von Unknown
1 Downloads
1 Likes
0 Makes
Zum Modell
I made this camera mount for use with FPV board cameras. The slotted holes are matched to the FliteTest "Electrohub" base plate when used in "X" configuration. There are also holes for the camera wires in four positions so that the mount can be attached in any of four orientations, based on your preference.
Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Flite Test Versacopter V2 20 Degree Camera Bumper
Flite Test Versacopter V2 20 Degree Camera Bumper
von luodanli
↓ 15 ♥ 16
FT Versacopter Mobius/Full Size Board Cam Mount 20 Degree
FT Versacopter Mobius/Full Size Board Cam Mount 20 Degree
von BankNYank
↓ 10 ♥ 7
FT Nano Flerken FPV cam mount
FT Nano Flerken FPV cam mount
von RaraSVT
↓ 3 ♥ 3
FT Super Bee camera mount for HS1177
FT Super Bee camera mount for HS1177
von redparchel
↓ 17 ♥ 6
fatshark cmos 700 v2 u bracket mount
fatshark cmos 700 v2 u bracket mount
von frederikv26
↓ 1 ♥ 2
Eachine Kamera TX05 support FPV
Eachine Kamera TX05 support FPV
von robertbba
↓ 4 ♥ 7
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
· Impressum · Datenschutz
DE EN FR ES IT NL

Zur Sammlung hinzufügen